SOP make up the Bed in hotel use 3 sheets - Hospitality Hotel Knowledge

SOP make up the Bed in hotel use 3 sheets 

The first step is preparation 

1. Remove soiled bed linen from the bed. 

2. Look at the bed protector to see if it is stained, torn or damaged. If it is not straighten it and make sure the mattress and box spring are even. 

3. Always adjust the mattress with your leg and not with your back to avoid any injuries. 

4. If the bed protector is stained then remove it. 

5. Use a clean bed protector and place it on the mattress: 

6. Lay the fresh bed protector on the bed. 

7. Unfold the bed protector right-side up and spread it evenly over the centre of the bed. 

8. Always smooth out any wrinkles. 

9. Bed protector comes in different size, be sure to use the correct size. 

10. Make sure you have the correct size sheets. 

11. Do not use a stained or torn sheet. Place them immediately in your solid linen bag. 

12. Take three fresh sheets and 4 pillows cover / slips as per the bed size. Bed protector example picture  

Bed Protector Picture

The second step is Making the bed: 

 1. Pull the bed a little away from the headboard. 

2. Spread the 1st bed sheet and tuck the bottom side of the bed except for the four corners. 

3. Take the loose end of the sheet, about a foot from the corner at the head of the bed and pull it straight out, foaming a flap. Pull up the flap so it is flat. 

4. Tuck in the free part of the corner. 

5. Pull the flap out toward you and down over the side of the bed. Tuck the flap in. 

6. Move to the corner at the foot of the bed on the same side of the bed and repeat the procedure. 

7. Spread the second sheet the wrong side up, from the edge of mattress. 

8. Put lower than the 2nd sheet. 

9. Spread the third sheet over the quilt. 

10. Fold the second sheet above the quilt and the third sheet 

 11. Tightly tuck the sheets under the mattress. 

12. Go towards the foot of the bed and tightly tuck the second sheet, quilt and third sheet together. 

13. Maitre the corners. 

14. Inset the pillows into the new pillowcase and tuck in the loose ends. 

15. Repeat this process for the other pillows. 

16. Place the pillow on the bed with the tucked edges facing the centre and the tucked flaps on the other side of the pillows. 

17. Position the bedspread on the bed with equal amounts hanging over both sides and the foot of the bed. 

18. Report to the supervisor if you notice stains or tears in the bedspread. 

19. Smooth the bedspread over the pillows to the head of the bed. 

20. Tuck the remaining of the bedspread under the front edge of the pillows. 

21. Smooth the surface of the bed. 

22. Check the bedspread for evenness on both sides. 

23. Push back bed towards the side of headboard in the exact position. 

24. All the four corners of the bed is mitered properly. Bed linen is stain free and properly pressed. Bed has to be firm. 

25. Give distance of the pillow from Headboard to the fold of the bed.